...flag moves up while the paper is making its way out of the printer and drops as soon as the paper drops into the output bin. When the tray is full the flag will stay activated or in the "up" position ...
...flag in the output bin that lets the printer know when there is too much paper on top of the printer and it stops so that the papers do not continue to feed out and overflow. Either the flag is stuck ...
Question about MFC 7420 All-In-One Laser Printer
...flag that is out of place in the printer. Remove the paper tray and you will see 2 flags on the underside of the printer. Power off, remove the toner cartridge and turn the printer upside down. I ...
...printer off, hold up the flag while pwring on, wait until al the lights stop cycling. the only light remaining ON (flashing) should be "Remove Output". Release the Output Bin flag; the light should ...
Question about DCP-7020 All-In-One Laser Printer
...Printer will not work. Keep getting same message. The black flap inside the rear door has a sensor flag mounted on it. The flag goes thru a hole on the side. If the spring is missing or broken or the ...
Question about 105Se Thermal Printer
...Flag. It is located on the electronic side of the printer. You need to take off the side cover (with printer turned off). The lever that raises and closes the printhead is attached to a shaft (the ...
...flag. It is located on the electronic side of the printer. You need to take off the side cover (with printer turned off). The lever that raises and closes the printhead is attached to a shaft (the ...
...the upright position. If the flag does not move freely, or return to the upright position, an error message (13.20.00 JAM) will appear on the control-panel display when the printer power is turned
...reaches upper bin, you can observe a flag moving while paper coming out. once this flag is stopped moving printer treates bin full..check the flag is moving freely. open top cover clean this
...cavity where the cartridge is inserted and you should see a flag there that gets pressed by the cartridge. The problem usually requires removing the back panel of the printer and reseating the
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,161 Questions
2,149 Questions
1,912 Questions
