Questions & Answers for: Topcon rl error Computers & Internet

rl-hb wont level I have one of this model too and have the same problem. It spin and spin but won't level. After a couple of minutes it stops and the power led fast blink. One guy says disassemble

...parts still available for these lasers, and that is only because they share them with the RL-H3A, which was only discontinued in 2011. If none of the above will make it turn on, you'd need ...

No laser beam on topcon rlh3c laser level Take this to a survey/laser repair shop, preferably one that does not charge for estimates.. The laser diodes on the RL-H3C is not serviceable. It requires ...

it making a noise like it jamed up it wownt lazer up The RL-H3C is nothing but lubricant covered gears and motors inside. Likely a piece of sand has become lodged in one of the gears. 4 Screws in the ...

...is different for different models, but i have attached some pictures from the manual for the RL-VH4

what is the slope buttons used for If you have the standard RL-H3C then there are 3 buttons. Starting from the left there is the "height alert" then "manual" then "Power". Height alert is a function ...

How do I get a user manual for a Topcon RL-H4c http://www.benchmarksupply.com/SUPPORT/RLH4C_RevE0124.pdf for as long as the link is valid here is a copy.

When I turn on the RLH4C laser level all lights flashing no rotating laser Hope This Helps You have a motor jam, or a bad compensator (vial). The unit has likely been dropped. Most laser dealers with ...

I dropped my Topcon RL-60B. I can visually see that the driving gear is out of alignment. Is it possible to replace the motor with a similar version from Maxon? There are 2 small screws holding the ...

On my Topcon rl-sv2s the instrument will spin but there is no red beam how can I fix this No one will tell you exactly. There could be several variants, you have to disassemble the device and look at ...