sensor, re-seat all connectors between the sensor and the process driver PWB. Recalibrate the DM sensors using simulation 44-02 (press execute). If F2 error still occurs, replace DM sensor or the drum
...44 and start then 2 and start - this will run the process control gain adjustment. You can also clear the error by running sim 14. If the error continues after both of these then it could mean a bad ...
...44 and press start key then 2 and start key again. Once it is finished running restart the copier. If this fails you need to look at the drum and possibly change it. ER-M550U GET ERROR CODE E7-60 ...
...error codes. It should be a process control code. F2-31 or F2-37, Drum mark or image density. You can execute 44-6. This should show which is out of range. Pull the drum unit out & clean both ...
...31 sensor image After clearing an H5-01 error message and after the system restart an F2-31 error message came up. I am unable to use SIM 44-02 effectively. What else should I do? Call a service
Usually answered in minutes!
203 Questions
45 Questions
25 Questions
19 Questions
30 Questions
